Pitney-bowes DI425 FastPac Inserting Systems Uživatelský manuál stáhnout pdf (Strana 34)

2 • Operation

2-18 SV61656 Rev. A

Fold B

Select the size of the second fold

required.

In a manner similar to that of fold

A, the machine suggests the cor-

rect dimension for the fold.

If you want to change the stan-

dard setting, press Change (+/-) until the length of fold required dis-

plays. The symbol | –––– | shows the fold panel you’re adjusting.

When the setting is correct, press Next (►) to advance to the next

setting…

If you’re programming an inserting job, the envelope depth setting

now appears. If you’re programming a fold-only job, the display goes

straight to the Confirming the Job Setup section explained on page

2-20.

Envelope Depth

Select the depth of your enve-

lopes (in millimeters).

Again, you can use the scale on

the front cover to measure the

depth of your envelopes.

Press Change (+/-) until the cor-

rect dimension is displayed.

When you’ve set envelope depth as required, press Next (►) to go

to the next setting…

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 99 100

Žádné komentáře

Pitney-bowes DI425 FastPac Inserting Systems Uživatelský manuál Strana 34